三公

The difference between an air 三公 and an oxygen 三公

The difference between an air 三公 and an oxygen 三公

Maybe you only know the air 三公 because it is the most widely used type of 三公. However, oxygen 三公s, nitrogen 三公s, and hydrogen 三公s are also common in 三公s. This article highlights how to help you understand the differences between which type of 三公 and oxygen 三公 you want.

You'll know：

What is an air 三公?

What is an oxygen 三公?

The difference between an air 三公 and an oxygen 三公

What is an air 三公？

An air 三公 is a device that stores power (using an electric motor, diesel or gasoline engine, etc.) in pressurized air (i. e., compressed air). By one of several methods the power of the air 三公 is increasingly compressed air, then, in the tank maintained until called put into use. The compressed air energy contained in can be used in a variety of applications, using the kinetic energy of the air because it is released and the container is down. When the tank pressure and reaches its lower limit, the air 三公 turns and rethe tank. Since it can be used for any gas / air while the pump in liquid operation must be differentiated from the pump.

What is an oxygen 三公？

An oxygen 三公 is used to pressure oxygen and provide it. Oxygen is a violent combustion agent that can easily cause combustion and explosion.

The difference between an air 三公 and an oxygen 三公

The air 三公 presses the air directly into the container. The air compressed by the air 三公 consists of two parts: 78% nitrogen; 20-21% oxygen; 1-2% water vapor, carbon dioxide and other gases. The air in the "component" does not change after compression, but the size of the space of these molecules occupies.

The oxygen 三公 contains oxygen that is compressed directly by oxygen. The compressed gas is highly pure oxygen and occupies little space.

The difference between an oxygen 三公 and an air 三公 is to ensure that it is oil-free.

1. All parts touching the oxygen contact in the screw air 三公 must be strictly skim and skim before being loaded. Clean with tetracloride to avoid exploding carbon.

When replacing or repairing parts that will come in contact with compressed oxygen. 2. Maintenance personnel must wash their hands first. The table and spare parts cabinet must also be cleaned and oil free.

3. The amount of lubricating water of the oxygen 三公 should not be too small or moisture to avoid sharp temperature rise in the cylinder; the cooling water for the blasting cylinder and cooler must be lower than the hyperbaric oxygen flow.

4. When the pressure change of the oxygen 三公 is abnormal, the relevant valve should be replaced or repaired at time to avoid the rising cylinder temperature.

5. Pay attention to the working state of the shoe upper and the letters of the middle seat of the sealed oxygen 三公. If the sealing conditions are not good, the filling port can be used at time to prevent the oil from being lifted to the oxygen 三公 by the piston rod cylinder.